Install ICOM 706MK2G in Mitsubishi outlander XL 2007′

Read more
Install ICOM 706MK2G in Mitsubishi outlander XL 2007′

Read more
The Kenwood PS-430 power supply provides 13.8 VDC at 20 amps intermittent (25% duty cycle), 15 amps standard (50% duty cycle) or 10 amps maximum at continuous load. Ripple voltage is less than 20 mW at 13.8VDC 15 A. Input is 120/220/240 VAC 480W. The power supply employs a 6 amp AC fuse and 20 amp DC fuse. The rear panel has a hard-wire Kenwood power cable to connect directly to the TS-430S. There are also “plus” and “minus” terminal outputs (10 amps max). The rear panel has a fan. A snap-down tilt bail is featured on the bottom panel to increase the operating angle. 6.8 x 3.75 x 9.675 inches 15.4 Lbs. (7 kg).

Read more

Read more
моя коллекция старья пополнилась еще одним приемником.

Read more
YAESU FT-850M + Delta 15m

Read more
ну вот и первые связи на новом месте. Icom 706MK2G и веревка из окна на деревья около 20 метров. бросали бутылку на ветки с UТ0UM до полуночи.
незабываемые впечатления от связей на 80-ке с организованными группами радиолюбителей из Донецкой и Луганской областей. рапорты 59+20дБ в обе стороны. ура, товарищи!


It was nice radio, but just sold…
Wouxun KG-UVD1

Kenwood TK-K4AT

 
My mobile radio VHF/UHF is Yaesu FT-7800R.

SPECIFICATIONS
Read more
My base radio is ICOM IC 7400.

SPECIFICATIONS
Read more